Calling all shooters - Page 2 - Tilted Forum Project Discussion Community

SuperMidget · 01-08-2004, 10:18 PM

yeah, all the Nitro's were rimmed cartridges. They were taken from the .45-70, .45-110, .45-120, and the .50-120 calibers.

Not important, I was just curious if it was different than the .500. appearently not. Thanks for the info and timely response.

Blistex · 01-10-2004, 02:28 AM

7.92mm I don't know about the United States, but those suckers are almost impossible to get here in Canada! It's easier to stretch the neck out on a 30-06, or use toned down 8mm.

p.s. anyone know a good 7.92mm supplier in Canada with reasonable prices? Non-Corrosive would be a plus!

Moonduck · 01-10-2004, 11:51 PM

7.92mm isn't all that hard here, though I can't help you in Canada =(

royal · 01-12-2004, 12:29 PM

I have a 7mm-300 Weatherby Magnum that is a very flat shooting, long range and acurate caliber. This is a 300 Weatherby Magnum necked down for a 7mm bullet. The only draw back is that it takes about 3-4 hours to load the shells and you can only get 3 reloads max out of the brass.

01-08-2004, 10:18 PM	#41 (permalink)
SuperMidget Banned Location: Farm country, South Dakota	yeah, all the Nitro's were rimmed cartridges. They were taken from the .45-70, .45-110, .45-120, and the .50-120 calibers. Not important, I was just curious if it was different than the .500. appearently not. Thanks for the info and timely response.

01-10-2004, 02:28 AM	#42 (permalink)
Blistex Psycho Location: Tiger I Turret	7.92mm I don't know about the United States, but those suckers are almost impossible to get here in Canada! It's easier to stretch the neck out on a 30-06, or use toned down 8mm. p.s. anyone know a good 7.92mm supplier in Canada with reasonable prices? Non-Corrosive would be a plus!

01-10-2004, 11:51 PM	#43 (permalink)
Moonduck Junkie Location: SE USA	7.92mm isn't all that hard here, though I can't help you in Canada =(

01-12-2004, 12:29 PM	#44 (permalink)
royal Upright	I have a 7mm-300 Weatherby Magnum that is a very flat shooting, long range and acurate caliber. This is a 300 Weatherby Magnum necked down for a 7mm bullet. The only draw back is that it takes about 3-4 hours to load the shells and you can only get 3 reloads max out of the brass.