|
10-18-2004, 10:20 PM
|
#1 (permalink) |
|
Insane
Location: California
|
A question about Distribution Amps
I need to install a Distribution Amp to clean up my cable tv signal. My question is, can I use a splitter after the Amp, or do I have to install the Amp at the end of each cable drop?
__________________
"I contend that we are both atheists. I just believe in one fewer god than you do. When you understand why you dismiss all other possible gods, you will understand why I dismiss yours." -Stephen F. Roberts IF PWNED > OWNED and PWNED=PWNAGE and OWN<PWN but PWN<PWNED and OWNAGE>OWN then what does OWNAGE+PWN equal? |
|
|
10-19-2004, 09:20 AM
|
#2 (permalink) |
|
Upright
|
I have my distribution amp right where the main cable comes in to my house. The amp I have has 5 outputs. If you need to split a cable in one of your rooms, you can do so. I have a splitter on the cable in my living room, one to the cable box and one to my DVR.
|
|
|
|
10-19-2004, 04:23 PM
|
#3 (permalink) |
|
Insane
Location: California
|
I would like nothing more then to put the amp where the cable comes in, but I'd need to buy a water tight box and figure out how to run power to it.
I might look into that down the ling though.
__________________
"I contend that we are both atheists. I just believe in one fewer god than you do. When you understand why you dismiss all other possible gods, you will understand why I dismiss yours." -Stephen F. Roberts IF PWNED > OWNED and PWNED=PWNAGE and OWN<PWN but PWN<PWNED and OWNAGE>OWN then what does OWNAGE+PWN equal? |
|
|
| Tags |
| amps, distribution, question |
|
|
