Smackre

im tring to fix a friends computer. And after reformating hes HD from my comp i put it back in hes. And forgot how the slave/master thing was hooked up. So i look at it and some reason its not like most HD/drives in general where you got one slot for slave one for master and one for sumtin else. Well this has 5 slots. If someone can explain to me how to host pictures ill post some pics of it. And on top it was a diagram that i dont understand.
its a old Maxtor 9108d5
Diagram:
Jumper/master/slave
j50 / on / off
i wanna hook it up so it is master with out a slave.
lemme know what you guys thinki need to do with it.

__________________
Intel® Pentium® M Processor 730 (1.60 GHz/2MB Cache/533MHz FSB)
17 inch UltraSharp™ Wide Screen XGA+ Display
1GB Dual Channel DDR2 SDRAM at 533MHz 2 Dimm
256MB NVIDA® GeForce™ Go 6800

sailor

If I understand what you are asking, there is usually a diagram/picture on there that tells you how to set it. It should be easy to understand. It usually set up as if you were looking directly at the pins. The different types (master, slave, etc) may be abreviated.

Please try to proofread your posts, this was very difficult to understand.

__________________
"Good people do not need laws to tell them to act responsibly, while bad people will find a way around the laws."
--Plato

j8ear

I'm not sure what you mean by 'five slots' but if your talking about the machine case, this is irrelevant to your predicament. In fact from the info you provided, you need to find the two pins labeled j50, and jump them. That is put a jumper accross them so the drive is identified as a master. You also then need to plug the drive into the correct connector on the ribbon cable. Some it doesn't matter, some label each connector with master or slave.

What do you mean by 'five slots?'

-bear

here is a link to the manual for that model drive on maxtor's site:

LINK

__________________
It's alot easier to ask for forgiveness then it is to ask for permission.

Smackre

sorry about hard to understand. i ment that there is 5 sets of pins not the normal 3 or 4 i usualy see

j8ear

Still don't get it

If one of those sets of pins is labeled j50....that is exactly what you need to place a jumper across.

-bear

EDIT: Did you look at that link to the manual I provided above?

__________________
It's alot easier to ask for forgiveness then it is to ask for permission.

Smackre

yes i did. And i hooked it up to the j50 jumper and still when i turn comp on it does not reconise my primary ide. i dont think its the HD cuz i tried 2 more and both did not work. But it will work with CD drives. not realy sure. any suggestions?

Lasereth

You gotta remember that even if you get the jumper setting correct on the HDD, you still have to put it on the right connector on the IDE cable. Make sure the HDD is on the Master connector on the IDE cable, not the Slave.

I'd try to help with the jumper settings, but the settings vary for each HDD. There's not much we can do without pictures.

-Lasereth

__________________
"A Darwinian attacks his theory, seeking to find flaws. An ID believer defends his theory, seeking to conceal flaws." -Roger Ebert

Smackre

the ide cable only has a connector on each end. no in the middle so i figured it was one end motherboard other end master..