Tilted Forum Project Discussion Community  

Go Back   Tilted Forum Project Discussion Community > Interests > Tilted Motors


 
 
LinkBack Thread Tools
Old 04-22-2004, 01:48 PM   #1 (permalink)
Insane
 
Removing paint that rubbed off on my car from a wreck

So I rear-ended an old man and his wife on my way home today

Anyway, there appears to be no damage except for some light scratches and this paint that rubbed off of the storage box on the back of his trailer. The old guy was really nice. I got out my truck and asked if everyone was OK. He said they were fine and "I don't really care about that old box anyway." So we parted ways.

I'm assuming this is just a hardware store bought oil-based paint because it is not scaping off with my fingernail. Anyone know of any good products that will take this stuiff off without damaging the clear coat?

__________________
If I say a chicken can pull a boxcar, hitch it up.

Last edited by messy; 04-22-2004 at 01:53 PM..
messy is offline  
Old 04-22-2004, 02:59 PM   #2 (permalink)
Loser
 
Should come off with any regular compound and polish. I prefer Meguiars brand.
WarWagon is offline  
Old 04-22-2004, 03:15 PM   #3 (permalink)
Psycho
 
Location: Sarasota
Abrasive compounds are death on a clear coat. Read the bottle/can first!
bodypainter is offline  
Old 04-22-2004, 07:35 PM   #4 (permalink)
Tilted
 
Location: San Antonio TX
I've used nail polish remover and or Goo Gone in the past, its worked but I seriously doubt its good for the clear coat
SmileyG3 is offline  
Old 04-22-2004, 08:38 PM   #5 (permalink)
Loser
 
Depending on just how stuck on it is, there are two things we used to do back at the shop. If it won't come off with any cleaners and is really on there good, we would do a wet sand with VERY fine grit paper, or use a fine cut cleaner. We'd follow it up with some medallion afterwards, and then either meguiars hand polish or swirl remover.


Or, you could try Meguiars Scratch-X
WarWagon is offline  
Old 04-23-2004, 06:34 AM   #6 (permalink)
Lost!!
 
Scorps's Avatar
 
Location: Kingston, Ontario
Go to a coin-wash....that might work, High pressure soap!
Scorps is offline  
Old 04-23-2004, 03:40 PM   #7 (permalink)
Junkie
 
Location: SE USA
With that much paint transfer, your clear is probably damaged. That said, WarWagon's advice is strong. The caveat is that you should be EXTREMELY careful when messing around with anything abrasive and your paint.

Realistically, it is a coupla hours worth of repair, a bumper cover R&I (remove and install), and a coupla hours worth of paint to do it right, if you cannot remove it with some rubbing compound or whatnot.

So your options are:
1) Do it yourself. This means taking a chance with a fairly expensive finish.

2) See if a Detailer can do it. A better option, as a good detailer is used to taking a finish to the edge of damage, and then making it look lovely afterward. Still, you take the chance that they will not be able to do it, and you will wind up paying for Option 3 anyway.

3) Take it to a bodyshop and have it done right.

Lastly, make very sure that your headlight did not take a knock. The direction of damage leads right to your liht. It is entirely possible that the storage box hit your grill. When that happens on Trailblazers, you frequently see cracks on the backside of the headlight. Basically, you give a good strong shaking and see if there is any movement.
Moonduck is offline  
Old 04-23-2004, 03:52 PM   #8 (permalink)
Insane
 
Thanks for the replies. I think my first plan of action is going to be taking it to a detail shop an see if they can buff it out somehow. After looking at more closely, there are numerous scratches all around the white paint. I'll deal with that later.

Right now though, I just want to get the white paint off.
__________________
If I say a chicken can pull a boxcar, hitch it up.
messy is offline  
Old 04-23-2004, 08:42 PM   #9 (permalink)
MSD
The sky calls to us ...
 
MSD's Avatar
 
Super Moderator
Location: CT
Don't use nail polish remover, it will bubble clearcoat.

If you can't get it out with polishing compound, my uncle taught me a little trick: spray a small amount of WD-40 on a rag and it will dissolve the rubbed-off paint, but not the clearcoat.
MSD is offline  
 

Tags
car, paint, removing, rubbed, wreck


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -8. The time now is 09:56 PM.

Tilted Forum Project

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
© 2002-2012 Tilted Forum Project

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261 262 263 264 265 266 267 268 269 270 271 272 273 274 275 276 277 278 279 280 281 282 283 284 285 286 287 288 289 290 291 292 293 294 295 296 297 298 299 300 301 302 303 304 305 306 307 308 309 310 311 312 313 314 315 316 317 318 319 320 321 322 323 324 325 326 327 328 329 330 331 332 333 334 335 336 337 338 339 340 341 342 343 344 345 346 347 348 349 350 351 352 353 354 355 356 357 358 359 360