Tilted Forum Project Discussion Community - View Single Post - Ball Joints...... Some Helping Advice Please

RaDiAn · 02-18-2004, 06:11 PM

I was suprised to see only one reply......Owell Thanks for the reply Peryn. I was able to get them off. The second one was much easier. I was able to leave the supspension hang. I used a ball joint tool with made it much easier to disconect it from the knuckle. I went for the bottom first and then the top. I remove all the nuts on ball joints and removed tie rod from the knuckle. Little help from the jack the new tool ,and a air hammer pickle fork, and it "flew off"

I was also not happy with the Hyanes manual it was very generic with the details.

Thanks again........ I will be putting back together this weekend!

02-18-2004, 06:11 PM	#3 (permalink)
RaDiAn Addict	I was suprised to see only one reply......Owell Thanks for the reply Peryn. I was able to get them off. The second one was much easier. I was able to leave the supspension hang. I used a ball joint tool with made it much easier to disconect it from the knuckle. I went for the bottom first and then the top. I remove all the nuts on ball joints and removed tie rod from the knuckle. Little help from the jack the new tool ,and a air hammer pickle fork, and it "flew off" I was also not happy with the Hyanes manual it was very generic with the details. Thanks again........ I will be putting back together this weekend!