View Single Post
Old 01-24-2004, 09:27 AM   #4 (permalink)
nanofever
Huzzah for Welcome Week, Much beer shall I imbibe.
 
Location: UCSB
Quote:
Originally posted by tritium
350w might be able to pull it off, but without seeing the amp info for each of the rails, I can't tell you any more than that. I usually drop in nothing less than 400w, but that's me...

Why not get an ATI card instead of the geforce?
Cost, a 200 dollar 5900 is quite cheap and can become a 5950U with a little bit of luck and prodding.

Went looking and found the same case sans-PS for 20 dollars and a pretty good 450w ps for 40 dollars

Type: ATX
Maximum Power: 450W
PFC: No
Power Good Signal: 100-500ms
Hold-up Time: Not specified
Efficiency: 65% minimum, 75% typical, at full load
Over Voltage Protection: +3.3V, +5V, +12V
Overload Protection: Not specified
Input Voltage: Select 90-132VAC or 180-264VAC
Input Frequency Range: 47-63 Hz
Input Current: Not specified
Output: +3.3V@28A;+5V@50A;-5V@0.8A;+12V@18A;-12V@1A;+5VSB@2.5A
MTBF: 50,000 hours
Approvals: UL, CSA, TUV, NEMKO, DEMKO, SEMKO, FI,CE

Would that work ?
__________________
I'm leaving for the University of California: Santa Barbara in 5 hours, give me your best college advice - things I need, good ideas, bad ideas, nooky, ect.

Originally Posted by Norseman on another forum:
"Yeah, the problem with the world is the stupid people are all cocksure of themselves and the intellectuals are full of doubt."
nanofever is offline  
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73