Thread: Plaster & Lathe
View Single Post
Old 02-06-2011, 10:42 AM   #1 (permalink)
samuel333
Upright
 
Plaster & Lathe

Does anyone have any suggestions for cutting through a plaster and lathe ceiling while minimizing dust and damage? I've used a reciprocating saw in the past, but there's a lot of dust with those and the saw causes the lathe to vibrate and the plaster around the cut to crack and extend the repair. The hole I have to cut is roughly two feet by three feet.

Thanks!
samuel333 is offline  
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73