Originally Posted by crad68

all the holes you plugged up with putty are set on angles,take a wire hangar and bend it strait with pliers ,you only need about 12" and ten bend a angle about 3" and slide into each hole around bowl flush and repeat ,also if you have a small shop vac suck the water out of the bowl and take dentist type of angle mirror and shine a flash light into bottom as your looking into mirror to see if there is anything trapped ,you might not see it if is farther down you must remove toilet ,also remove your water supply to the toilet assuming it is a flex supply and turn on water to see if you have a good pressure feeding into the toilet also i would replace your ball cock with a cheap consumer freindley type that tells you how to put it together usually 5min suck out water from tank with wet vac first and replace the water supply line if you change it,