View Single Post
Old 09-15-2007, 07:39 AM   #1 (permalink)
Push-Pull
I'll ask when I'm ready....
 
Push-Pull's Avatar
 
Location: Firmly in the middle....
Any tips on sighting in a scope on an M48?

OK, I have a Yugo M48A. Pretty clean, shoots well with the iron sights, consistently puts lots of holes in black at 200 yards. Found a Russian scope with dovetail mount that was easy enough for this novice gunsmith to mount. I just got it horizontally aligned as good as possible by clamping it in my milling machine vice and sighting in on a telephone pole about 1/2 mile away, comparing it with the iron sights and down the barrel. I then did the same for the vertical by zeroing on a neighbor's fence rail at about 300 feet with the elevation knob at that distance. (well 100 meters, you get the idea....)

So now the fine tuning. Should I just set up a shooter's block and start putting holes in paper and adjusting as necessary? How far back should I be to start? How far back should I end up? I've read to dial it in at 400 yards so that you don't have to adjust elevation as much, just aim a little higher/lower.

I'd really like to get this nailed down tight, so any tips would be appreciated. TIA!
__________________
"No laws, no matter how rigidly enforced, can protect a person from their own stupidity." -Me-

"Some people are like Slinkies..... They are not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs." -Unknown-

DAMMIT! -Jack Bauer-
Push-Pull is offline  
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76