|
Thank you for your quick response. Here is my HD setup as well as I can describe it. I am not completely sure about the IDE cable setup, but what I will be calling IDE1 is attached to a blue slot on my motherboard, and the IDE2 is from an all black slot that has the DVD drives.
Disk 1 (OS drive)
IDE1, grey (middle) = IBM Model: IC35L060AVVA07-0 61.4 jumpered as Device 0 (Master) per instructions on the line that I think is for 16 heads, as opposed to the bottom line which is for 15 heads.
Disk 2 (MassStorage)
IDE1, black (end) = Maxtor DiamondMax 16 250GB ATA/133 HDD jumpered as, if I am reading this right, Spare. See bottom for explanation.
DVD drive
IDE2, grey (middle) = I cannot really get it out to look with ease, but it is jumpered as Slave.
DVD RW drive
IDE2, black (end) = Not pulling it out either unless absolutely necessary, but jumpered as Master.
Drive 2 jumpers:
The jumper pins are in a 2x5 grid with one missing, like so:
1,2,3,none,5
6,7,8,9,10
DS Master shows the jumper on pins 1 and 6
CS Enabled shows jumpers on 2 and 7
Cap Limit shows jumpers on 3 and 8
DS (slave) and Spare are on a merged arrow that points toward two jumper configurations shaded differently from all the others, on pins 2 and 3, and one that is on where pin 4 (absent) would be and pin 5. I am guessing that putting the jumper on pins 2 and 3 would set it as slave, and on 4 and 5 would store the pin as a spare? There is only one jumper on the drive currently.
|