Tilted Forum Project Discussion Community - View Single Post

Hard8s · 01-11-2005, 05:05 PM

Ah I see by the last pic. that your problem lies not in the screws but in the bits. There are 3 standard sizes for Phillips bits. The trick is to use the correct one for the screw. The correct one is usually the biggest on that will fit firmly in the screwhead, and then to go slowly so that they do not ramp out. But I can see to the victor go the spoils, and just send back those piece of crap bits to the furniture store, grab a beer, and relax on that comfortable couch!

01-11-2005, 05:05 PM	#2 (permalink)
Hard8s Addict Location: Wherever I am!	Ah I see by the last pic. that your problem lies not in the screws but in the bits. There are 3 standard sizes for Phillips bits. The trick is to use the correct one for the screw. The correct one is usually the biggest on that will fit firmly in the screwhead, and then to go slowly so that they do not ramp out. But I can see to the victor go the spoils, and just send back those piece of crap bits to the furniture store, grab a beer, and relax on that comfortable couch! __________________ If ignorance is bliss, then wipe this smile off my face!