View Single Post
Old 03-29-2004, 11:47 AM   #1 (permalink)
Peryn
Junkie
 
Location: San Diego, CA.
Anyone rebuilt a starter?

Ok, so we have a 1989 S-10 Blazer, 2WD with the craptacular 2.8L in it. Anyway, the starter is pretty much dead, and it looks to be teh drive gear. I haven't pulled it and looked at it, but im almost pretty much 100% sure that the overrunning clutch on it is toast. So rather than 100 bucks or so for a new starter, i wanna toss in the $10 to get a new clutch and gear, and reuse whats good in the old starter.

Now to my question. Unbelievably, i dont have a chiltons for this thing yet. Even then, im not sure that it would tell me how to rebuild a starter. Anywho, do you know if there are any other parts needed? I dont think there are, but before a order just the drive end, im curious if there are any bushings, bearings, washers, or any other minor parts i will need to replace this part? Id hate to pull it, dissasemble it, and find out that i need a bearing.

If any of you know, id appreciate it. And not just for this particular car, but for any car in general if you happen to know.
__________________
Dont cry kid, It's not your fault you suck.
Peryn is offline  
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76