0energy0

i had computer speakers and regular stereo speakers. i took apart my pc speaker and i was left with the chip inside. i tried to wire the stereo speakers to the chip and it did work for a bit. then after the chip blew up. =\. now i dont know what to do?

a-j

Throw it away and put the soldering iron back in the closet and pick up a book on electronics. Actually I'm not surprised that happened, the regular stereo speakers draw way too much current for the wimpy little powered computer speakers to supply.

shakran

the real way to do this is to run a line from your soundcard to an input on your receiver, then hook up the stereo speakers to the receiver (where they belong) and enjoy nicely amplified computer sounds.

sashime76

What exactly are you trying to do?? Cheap speakers can't handle the high outputs like stereo speakers. Don't misunderstand the PMPO rating, 1000 Watts PMPO IS NOT the same as rms. I think you need to learn basic electronics and do some research on the Internet before you heat up that soldering iron again.

skaven

Here, here. The amp you pulled out of those little computer speakers have nowhere near the capacity to drive a large set of speakers. If you're terribly attached to the speakers, just pick up a good quality amp (standard monitor 2 channel amp) from a music store, or if sound quality isn't your top priority, Radio Shack even has 25W amps that work pretty well.

Google around and I'm sure you'll find what you're looking for.

flat5

or get a used Hi Fi amp. Most thrift shops have 'em. Places like Salvation Army stores.
Pawn shops. etc.