Slim VGA
 

I am looking for a way to put a VGA cable in a peice of 3/4" pipe. The wire on the VGA cable fits fine but the ends are to big. And I dont really want to cut the end off and redo all those connections.

So I was wondering if anyone had any good ideas on how to do this. Or know of a slimer VGA cable?

I don't think you're going to find a vga cable that will fit. I have some pretty small vga connectors, but none of them will go in a 3/4" pipe.

It's not terribly difficult to wire your own vga cable. You can get the schematics online ... you can also get the connectors.

You could also cut the pipe lengthwise and stretch it open enough to put the cable in; then seal it back up.

Ethernet (or wireless) and VNC?

How long a run is this going to be, and how long is the pipe?

If you have to go the VGA route, it's easier to make an interference-resistant junction in the middle; split an existing cable instead of putting on a new end.

you can put VGA over cat5 with some adapters.

http://www.avsforum.com/avs-vb/showt...highlight=cat5

its only about a 10' run. I will probly go that route dilbert.