Tilted Forum Project Discussion Community - View Single Post

Jolt · 11-29-2004, 06:49 PM

Presuming you have a #15 Torx driver with an 8" shaft...getting into one of these is simple.

The logic board has one meg of memory on it, then there's an expansion card with a second meg on it, and the card has two slots for holding two 256kb or 1mb SIMMs. The max for this machine was a whopping 4mb to go along with its 8MHz 68000 cpu.

If you pull out the mem expansion and you can boot, but one meg isn't enough to boot your system...you can power on and hold down

"Command" "Option" "X" "O"

This will boot the machine from a minimal System 6.0.3 image stored in ROM...this was the only machine Apple did this with.

I have a Classic, a Plus, and an SE/30 in my collection. They make wonderful terminals.

11-29-2004, 06:49 PM	#3 (permalink)
Jolt Insane Location: Over here	Presuming you have a #15 Torx driver with an 8" shaft...getting into one of these is simple. The logic board has one meg of memory on it, then there's an expansion card with a second meg on it, and the card has two slots for holding two 256kb or 1mb SIMMs. The max for this machine was a whopping 4mb to go along with its 8MHz 68000 cpu. If you pull out the mem expansion and you can boot, but one meg isn't enough to boot your system...you can power on and hold down "Command" "Option" "X" "O" This will boot the machine from a minimal System 6.0.3 image stored in ROM...this was the only machine Apple did this with. I have a Classic, a Plus, and an SE/30 in my collection. They make wonderful terminals.